Temperature dial not working by fredadog



fredadog
Hi guys
Temp gauge not working done diag test number 2.0 all gauges go round ok except temp gauge.Temp gauge is getting power as red light comes on at start.
Any help or ideas greatly appreciated

Posted 07 Jun 2012, 18:05 #1 

User avatar
takestock
Sounds like a instrument panel failure, try on board diagnostics test 7.0 that will give you the digital temp readout in the IPK (Instrument pack (IPK from the German)).
Photobucket = Tossers

Dave....

Posted 07 Jun 2012, 18:08 #2 


fredadog
done that it did give the temp but why is gauge not working

Posted 07 Jun 2012, 18:09 #3 

User avatar
takestock
sounds like the gauge is broken then :)The fact the IPK gave a temp readout shows the rest of the system is working, not sure if the gauge itself is changeable as a stand alone part or it is a replacement IPK reqd .
Photobucket = Tossers

Dave....

Posted 07 Jun 2012, 18:12 #4 

User avatar
calibrax
If it's the motor that activates the gauge that's failed, it can be replaced with a bit of soldering. But if it's something electronic that's failed, it probably means a new IPK and a T4 (Testbook version 4.Computer Diagnostic System) session to pair it to the car.
Steve

2004 MG ZT+ CDTi 135


Image

Posted 07 Jun 2012, 18:17 #5 

User avatar
takestock
Either a T4 session or swap the eprom chip over seemingly ;) if you change the IPK
Photobucket = Tossers

Dave....

Posted 07 Jun 2012, 18:19 #6 


fredadog
wheres the motor that activates the gauge

Posted 07 Jun 2012, 18:24 #7 

User avatar
calibrax
The motor is right behind the needle. The IPK is quite fiddly to dismantle, but it can be done.
Steve

2004 MG ZT+ CDTi 135


Image

Posted 07 Jun 2012, 19:06 #8 

User avatar
Duncan
Yes, if it's the motor it should be straightwforward. It might even just be a duff soldered joint of the motor onto the board. It could be the drive chip as well.

The needles pull off, and take care when replacing them that they point to zero when the instrument pack resets. If you don't your speedo could be out and that's not helpful.
Image

Posted 07 Jun 2012, 19:15 #9 


Top